EnvirotexLite by ETI

Envirotex / EnvirotexLite

Envirotex Lite, an easy to use and beautiful pour-on plastic coating for all of your projects, air dries to a hard high gloss finish in about eight hours, completely cures within 36 to 48 hours after pouring, and best of all, it doesn’t require a degassing chamber or polishing to reach its signature shine. Made by Environmental Technology, Inc.,(ETI) it is not recommended for exterior use.

One coat of Envirotex produces an attractive, durable coating that is equivalent to up to 50 coats of varnish. Additional coats may be applied after curing by wiping the surface with an alcohol saturated clean cloth prior to recoating. Just scuff sand and then wipe clean before applying over polyurethane finishes.

Projects of all kinds receive a professional looking gloss finish with Envirotex Lite: resin tiles, bar tops, cypress clocks, wall plaques, table tops, shiny coasters, cabinet knobs, figurines, and embedded resin jewelry, model ponds and ice skating scenes.

Easy to use with no strong smell, Envirotex should be used in a well-ventilated, clean, dry, dust-free room where the humidity is below 50% and the temperature is between 70 and 80°F. Higher room temperatures up to 100°F after pouring shorten the cure rate while increasing the hardness.

Use about 4 to 6 ounces of Envirotex Lite per square foot for your projects. Mixing at 70°F makes Envirotex easy to mix and inhibits bubble formation. Once mixed, pour Envirotex immediately as you only have approximately 25 minutes of working time at 70°F, less at warmer temperatures.

Within ten minutes, bubbles will begin rising to the surface and breaking. Exhaling across the surface of your small item to break the bubbles; a small propane torch is recommended for large items.

Experts have been using Envirotex Lite for years to give a beautiful finish to their projects-now you can, too.

® Envirotex Lite is a registered trademark.

Full Article